So you’ve chosen your pattern, but either you don’t want to use the recommended yarn or you can’t find it to buy. This does not mean you are stuck. Many knitters, especially when they are just learning to knit, get stuck on the idea that you can only use the yarn that the pattern is written with. There are, occasionally, a few projects where it can be quite hard to find an alternative but that is very rare. There are a few factors that you want to think about when changing yarn. Yarn Thickness The main one is the thickness of the yarn. This is the one factor that you absolutely have to consider. Everything else that I discuss below helps to hone your decision down but yarn thickness is at the core of a project. If you use a thicker yarn, it could make the fabric too dense and often make it impossible to match the gauge of the pattern. If you use a thinner yarn, then it will be more open and airy than intended; there’s more scope with this but some projects such as toys an...
Recently, I was asked to help out with a project. This wonderful blanket (designed by Debbie Abrahams from her book, Blanket and Throws to Knit ) was knitted by Ann. I was asked to piece it together and back it. The finished blanket is being used to raise money for When you Wish Upon a Star. The yarn was donated by A Good Yarn and the fabric and cotton by L & C Fabrics . I thought I’d show you how I went about backing the blanket, I went about it as I would a quilt. Though, I decided tying would be the best way of layering it together, as traditional quilting would be difficult on a knitted fabric. 1. Block the blanket. I pinned it out and spritzed it. Normally, I would wet block, but I was concerned that the red may bleed and it would take some time to dry too. 2. My blanket was too large for a standard width so I pieced the backing. The backing should be a few inches larger than the knitted blanket. Place it right side down on the floor. I then tape it down o...
Everyone has their go-to or workhorse cast-on. More often than not it can be a Knitted cast-on or a Long-Tailed cast-on; or perhaps the Cable cast-on. The one I tend to use is the Twisted German cast-on, also known as Old Norwegian cast-on. For speed I’m going to call it – TGCO. The reasons I prefer this one are – I find it to be the quickest one to do (look at the video at the bottom to see how fast) It has a good balance between being a stretchy cast-on, as well as, springing back into place. I find the knitted cast-ons tend to be too tight for most situations. It creates a strong stable stitch that is easy to knit into on that first row. Some cast-ons can be very tricky or time-consuming on that first row. It is also a fantastic cast-on for top down socks – as it is so stretchy. Last year, I made a cast-on flow chart for the blog, which can be useful in determining what type of cast on to use. I prefer to learn from a photo tutorial but for those of you who pre...
Told you so! Those quilts are exquisite! Just know I'll be asking you about those as well as the fab temari balls x
ReplyDelete